The Aerial M4 is the solution for those who seek the highest flexibility from a flying probe tester, from production test to repair, all the way to reverse engineering.
The Aerial M4 has a vertical architecture with two flying test probes on each side, two additional Openfix probes and two cameras (one on each side respectively). This configuration allows the Aerial M4 to perform true in-circuit tests, giving full access even to boards that do not have all the test points on one side only, and the capability to place guarding points as well as use all of the vectorless test techniques for ICs, with or without powering up the UUT.
With probes and cameras on both sides of the UUT, the Aerial M4 is ideal for rebuilding the board netlist: the system can acquire the images of components, pads and test point coordinates, to enable the complete reverse engineering of the board, rebuilding the electrical schematics or even the CAD data of a product which has no design and/or manufacturing documentation.
More on the documents beside ------>
